What is Soft seal gate valve?BAODINGVALVULA shares that soft seal gate valve is a kind of most commonly used water supply valve with small fluid resistance and strong sealing performance.Product Features:Body material is from cast iron (GGG) and wedge is fully covered by NBR or EPDM. Spindle materia Read More

Difference between Soft seal gate valve and hard seal gate valveSoft seal gate valve and hard seal gate valve are two major categories in the gate valve series. Hard seal and soft seal can sometimes compensate for each other, and sometimes they are independent of each other. So what is the relations Read More

Since the introduction of the U.S. Clean Air Act in 1963, the U.S. Environmental Protection Agency (EPA), as well as individual states, have set increasingly stringent restrictions regulating fugitive emissions from industrial facilities. Fugitive emissions are any chemical in a physical form that c Read More

There are four general body styles of ball valves: single body, split body, top entry, and welded. There are four general types of ball valves: full port, standard port, reduced port, and v port. A full port ball valve has an oversized ball so that the hole in the ball is the same size as the pipeli Read More

We all know that valves are present in our everyday lives, but valves work a lot “behind the scenes”—controlling what might seem like the “uncontrollable”. Without valves, we would have engineering issues on how to regulate and control steam, water, air, corrosive liquids, gases and other materials Read More

Gate valves and ball valves are the most commonly used flow control valves in the market. They are generally used to control the flow of liquid and gases. Although they are used in similar settings, there are a few important differences between these two valves. We discuss the differences between ga Read More

Plug and gate valves are both stop-valves suitable for a wide array of applications and media types. For example, they can both be used for clean media and media containing solids or stringy material. Therefore, it may be difficult to determine which is more suitable for a specific application. This Read More

If you are in the valve world at all, you know that the plug valve oftentimes gets a bad rap. There are different reasons for this. One being that the maintenance for these valves is greater than that of other valves. They need to be lubricated while out in the field and more times than not, this is Read More

Ball valves are essential components of plumbing systems because they can quickly turn to stop the flow of water. With these quarter-turn valves, you can control a lever from the outside to turn off and on the water. Read More